|
|
|
 CERAMIC
FIXING INSTRUCTIONS
LIMESTONE
FIXING INSTRUCTIONS
POLAR RIVA
FIXING INSTRUCTIONS
PORCELAIN
TILE INSTRUCTIONS
SLATE
FIXING INSTRUCTIONS
MAINTENANCE
GUIDE
Below are the same guides in Polish (Polski)
LIMESTONE
FIXING INSTRUCTIONS in Polski
POLAR RIVA
FIXING INSTRUCTIONS in Polski
PORCELAIN
TILE INSTRUCTIONS in Polski
SLATE
FIXING INSTRUCTIONS in Polski
:: CERAMIC FIXING INSTRUCTIONS ::
Fixing instructions for Ceramic Tiles on to Suspended Timber Floor with Electric wire under floor heating
1 Ensure that Joists, floor boards, Waterproof ply, Tongue and grove etc are stable without excessive
movement, screwed down, dust free and dry.
2 Cut Ditra matting to fit area then fix using Ditra Adhesive. Ensure sheets are overlapped and a kerdi
matting skirting is used if the area is to be water proof.
3 Apply single part rapid flex white adhesive to the Ditra matting to create a level screed 2mm above
the Ditra matting. Allow to dry
4 Fix the under floor heating as per manufacturers instructions & test. Ensure that none of the heating
elements are in contact with matting.
5 Fix the Tiles with a minimum 2 mm joint using single part rapid flex white adhesive using a notched
trowel to create a 4 mm bed again ensure that none of the heating elements are in contact with the tile.
Allow to dry
6 Grout using a flexible floor grout
7 Clean and set up a regular maintenance programme.
8 Do not switch on the under floor heating on for at least 2 weeks and then only increase the
temperature above room temperature by 2 degree increments per day until the desired temperature has
been achieved.
Fixing instructions for Suspended timber floors or floors where there is a mix of substrates, cracked
old screed, green screed or water pipe underfloor heating systems
As above omit points 3 & 4 ie creating a screed etc, apply adhesive to the matting using a notched
trowel and fix tile immediately to create a 3 mm bed above the matting. Follow points 6,7,8 & 9.
Many fixers prefer fix Ceramic Tiles to a tile backer board or a minimum of 18 mm of water proof
plywood which is fine, although we do recommend the use of Ditra matting.
Fixing instructions for Screeded Floors with/without under floor heating
As above omit points1,2,3 & 4 i.e. creating a screed etc. apply adhesive direct to a primed screed
using a notched trowel and fix tile immediately to create a 3 mm bed. Follow points 6,7 & 8
N.B. New Screeds should dry out or cure before tiles can be laid; industry recommendation is 25 mm
per week, otherwise use ditra matting as above.
Fixing instructions for walls areas ie plaster/plasterboard, ply, backer board & render
As above omit points1,2,3 & 4 apply adhesive, one can use a Waterproof Tile Adhesive instead of SP Rapid Fix,
direct to a primed surface using a notched trowel and fix tile immediately to create a 3 mm bed.
Follow points 6,7 & 8
A LIST OF RECOMMENDED TILERS IS AVAILABLE ON PURCHASE.
|
|